Installing Roman Blinds

Step 01
Measure your installation height at 2 ends above the window frame.
Double-check that your installation height is levelled and points are properly aligned..

Installation height
Step 02
Mark your drill holes. Carefully drill your holes using the right drill.
• Drilling into brick, concrete, stone, or tile: Use a 5.5mm masonry drill bit and appropriate anchors and screws, and insert rawl plugs into them
• Drilling into plasterboard: Use an ordinary 5.5mm drill bit or Ramset 10 mm grip hollow wall anchor and insert rawl plugs
• Drilling into timber: Use an ordinary 2mm drill bit to create a pre-drill pilot hole and use screws. A few screws and red rawl plugs would be required to fix the brackets in position after drilling.

Drill bit comparison

Drill holes 1

Drill holes 2
Step 03
Clip your blinds into the brackets, and clip the handle design that is used to lower and raise the blind to the bottom rail.

01

02

03