Installing Roller Blinds

Measure your installation height in atleast 3 places and ensure that they are at the same level.

Measure the width of your blind and mark its every end such that they are aligned with your installation height.

Our roller blind brackets can be screwed onto your wall or your ceiling as per your needs and preferences.

Mark your drill holes. Carefully drill your holes.

• Drilling into brick, concrete, stone, or tile: Use a 5.5mm masonry drill bit and appropriate anchors and screws, and insert rawl plugs into them

• Drilling into plasterboard: Use an ordinary 5.5mm drill bit or Ramset 10 mm grip hollow wall anchor and insert rawl plugs

• Drilling into timber: Use an ordinary 2mm drill bit to create a pre-drill pilot hole and use screws

Fix the brackets in position, by flushing them into the plugs

The bracket is spring-loaded.

Place the spring-loaded pin into the hole. Hook the front tip on the inside front of the headrail, under the front tip of each bracket and rotate the headrail down and in until the back of the headrail clings into the back of the brackets. Hook the chain end into the cross.