Installing Roman Blinds

Measure your installation height at 2 ends above the window frame.

Double-check that your installation height is levelled and points are properly aligned..

Mark your drill holes. Carefully drill your holes using the right drill.

• Drilling into brick, concrete, stone, or tile: Use a 5.5mm masonry drill bit and appropriate anchors and screws, and insert rawl plugs into them

• Drilling into plasterboard: Use an ordinary 5.5mm drill bit or Ramset 10 mm grip hollow wall anchor and insert rawl plugs

• Drilling into timber: Use an ordinary 2mm drill bit to create a pre-drill pilot hole and use screws

A few screws and red rawl plugs would be required to fix the brackets in position after drilling.

Clip your blinds into the brackets, and clip the handle design that is used to lower and raise the blind to the bottom rail.